PCZ Heavy Hammer Crusher

One-time molding, no secondary crushing and shaping process is required, the cost can be reduced by about 40%, and the energy consumption is low.

The heavy-duty hammer crusher crushes the material by the collision of the high-speed hammer body and the material. It has the characteristics of simple structure, one-time forming, large crushing ratio, small product particle size and high production efficiency. It can be used for dry and wet crushing. It is suitable for It is used for fine crushing of medium hardness and brittle materials in mining, cement, coal, building materials, combustion and other departments. The hammer crusher can adjust the gap between the hammer head and the lining plate according to the user's requirements, and change the discharge particle size to meet the different crushing needs of different users, and is very popular among domestic and foreign users.

20-30mm、10-20mm、5-10mm、0-5mm

It can crush more than 100 kinds of rocks. The common discharge size is...

Reasonable gradation

Through three ingenious designs such as three counterattack zones, self-flow of finished materials, and adjustable trans-liners, the finished materials have reasonable gradation and low powder production, which can meet the diverse requirements of customers.

Easy maintenance

Eight-way hammer shaft hole, four-way spare, the body is equipped with an observation door, which is convenient to observe the operation. It is equipped with a hydraulic shaft puller, which is convenient for replacing the hammer head and hammer shaft.

Well made

All key components are protected by parts, processed by modern machinery and equipment such as gantry milling and presses, and a product technology department has been established to continuously improve processing technology and product quality.

Self-flow tank design, small powder yield

Leave a gap on the adjustable counterattack plate in the third counterattack zone, so that the material with a diameter smaller than the gap can flow out naturally, avoiding re-crushing, and greatly reducing the powder production rate while increasing the production capacity. It is an alternative to traditional Optional product for impact crusher.

The electromotor drives the rotor to rotate with high speed in the crushing chamber. The materials are fed into the machine from the upper feeding mouth and are crushed under the hitting, impacting, cutting and grinding of the hammer which is moving with high speed. On the bottom of the rotor, there is sieve plate and the crushed materials that is smaller than the screen size are discharged from the sieve plate, and the coarse particles bigger than the screen size are retained on the sieve plate to be hit and ground again by the hammer and finally be discharged from the machine from the sieve plate.

Over 40 years of production experience

SPOM specializes in the manufacture of aggregate aggregate solutions, grinding equipment and mobile stations. Customers are located in more than 120 countries and regions around the world.

Model	Feed Opening Size(mm)	Capacity(t/h)
PCZ1310	890X1075	150-180
PCZ1512	1200X900	250-400
PCZ1615	1480X1200	400-800
PCZ1620	2000X1200	800-1000
PCZ1820	2000X1200	800-1500
PCZ2020	2010X1200	1200-1600
PCZ2125	2600X1690	2000-3000
PCZ3032	3240X1840	4500-6000

Model	Feed Opening Size(mm)	Capacity(t/h)
PC0910	1070x750	150-200
PC1012	1255x810	250-300
PC1213	1350x900	300-350
PC1216	1530x920	400-500
PC1220	2000x920	500-700
PC1622	2290x960	600-900
PC1826	2550X1080	800-1200
PC2026	2550X1170	1000-1500

PRODUCT INTRODUCTION

Features

Reasonable gradation

Easy maintenance

Well made

Self-flow tank design, small powder yield

WORKING PRINCIPLE

TECHNICAL SPECIFICATIONS

Product Photos

Over 40 years of production experience

Service Support

Contact Info